torsdag 17. januar 2013

A day for milestones

Today was an important day in my 48 Panhead`s resurrection. I did the last repair job, not that there is no more wrenching to be done, nope I did the last cut, weld, file, drill job that was needed.

As I am back on track working on the gearbox it was time to repair the shifter shaft. As most holes, this was not even close to be round. Replaced half of the shifter shaft plate with a piece of rock solid offshore quality steel, will last for years.

Had to celebrate this with an extra beer!!







2 kommentarer:

  1. my knuck shifter is the same... i now see a good way forward, thanks for this!!!

    SvarSlett
  2. Rowan be my guest, it`s just me you know that hate oval holes. The steel I used is something like the ST52 quality, not just ordinary steel from the bin.

    SvarSlett